You are standing in your kitchen, and you notice the box on the wall where your electricity comes into the house. The old one had a spinning metal disk behind a glass bubble. The new one is a solid block of plastic with a digital display that blinks numbers. That is a smart meter, and there are over 147 million of them in the United States, counting homes and businesses together. If you moved into your house in the last ten years, one was probably already attached to the wall.
A smart meter is an electric meter with a small radio inside it. Nobody has to walk up to your house and read the dial anymore. The meter records how much electricity you use in short intervals, sometimes every fifteen minutes, sometimes every hour. Then it sends those readings back to the utility company over a wireless network. The industry calls this whole system AMI, which stands for advanced metering infrastructure. It is not a new technology. It has been rolling out for years, and most houses have one now.
The difference between this meter and the old analog meter is that the analog meter was just a mechanical counter. You could see the disk spin when you turned on a light. A person had to come by every month and write down the number. The smart meter does that job itself, and it does it more often. The utility gets a picture of your usage in near real time. That helps them manage the grid and spot outages faster. It also means your bill is based on actual readings, not estimates.
The meter does not transmit all day long. It sends data in short bursts. How often it sends depends on the utility’s network setup. Published measurements taken near smart meters show that the radio signal, when averaged over time, comes in at a small fraction of the limit set by the Federal Communications Commission. The level drops quickly as you walk away from the meter. Distance does most of the work. If you want to know the exact numbers for your specific meter model, the FCC keeps records of tested devices, and those are public.
Some people do not want a meter with a radio in their home. Most utilities will swap it out for a traditional meter without a radio. It is not free. Opting out usually costs a one-time fee plus a monthly charge. That monthly fee pays for someone to drive out and read the meter by hand. The amounts vary a lot from one utility to another. A few utilities, including the big ones in California, offer a lower rate for low-income customers. Your utility’s tariff is the document that actually sets your fee. You can read it before you call them.
If you have a health concern about the radio signals, that is a question for your doctor. If you want to know whether the utility is following the law, that is a question for a lawyer or your state public utilities commission. If you want to know the technical specifications of the meter and its radio, those are in the public records at the FCC. No sticker, shield or device sold on the internet has been shown in published studies to block the signal or protect your health in a meaningful way. The choice is yours, but it is best to get your information from the documents that actually regulate the equipment.
More notes on this topic are at Meter on the Wall.
